Dacor DOP36P86DLS Manuel D'installation page 29

To start the bake and broil burners:
NOTE
To change the temperature during cooking, use the temperature selector knob.
Install_DOP36P86DLS_DG68-01106E-00_EN+MES+CFR.indb 29
1. Rotate the mode selector knob from OFF
to Convection Bake, Convection
.
Roast, Pure Convection
2. Rotate the temperature selector knob
from the OFF position to change the
temperature. You can set the oven to
any temperature from LO to 550 °F.
• The gas oven preheats until it
reaches the temperature you set.
• When preheating is complete, place
the food in the gas oven, and then
close the door.
3. When cooking is complete, rotate both
mode and temperature selector knobs
to the OFF position, and then take out
the food.
To start the broil burners:
Broiling uses an upper gas oven alone to brown food. Meat or fish must be put on
a broiling grid in a broiling pan.
1.
2.
Checking the flame quality:
All combustion flames need to be visually checked to determine their flame
quality.
1.
2.
3.
If burner flame looks like 3, the range
should not be used until it is serviced. Call
Dacor for service. Normal burner flames
shall look like 1 or 2, depending on the gas
type you use.
Turn the mode selector knob from OFF
to the Broil position, and then rotate
the temperature selector knob to set
the broiling temperature from OFF to
HI or LO.
When broiling on either side is
complete, rotate both mode and
temperature selector knobs to the OFF
position.
Prevailing soft blue flames—Normal for
natural gas operation.
Yellow tips on outer cones—Normal for
LP gas operation.
Yellow flames—Abnormal for any gas
operation; call for service.
NOTE
English 29
2020-07-01 오후 3:44:12