Installation Guide - Dacor DOP36P86DLS Manuel D'installation

Masquer les pouces Voir aussi pour DOP36P86DLS:

Manuel d'utilisation (180 pages)

Table des Matières

Les langues disponibles

Minimum dimensions

CAUTION

•

If overhead cabinets are installed, a range hood should also be installed

and project horizontally a minimum of 5" (12.7 cm) beyond the front of the

cabinets. Hood is necessary to dissipate any heat buildup in the overhead

cabinets to prevent possibility of fire, personal injury and/or death. The

ventilating hood must be constructed of sheet metal not less than 0.0122"

thick and installed above the cooktop with a clearance of not less than ¼"

between the hood and the underside of the combustible material or metal

cabinet. The hood must be at least as wide as the appliance and centered over

the appliance. Clearance between the cooking surface and the ventilation hood

surface must never be less than 24".

•

Exception 1 : Installation of a listed microwave oven or cooking appliance

over the cooktop shall conform to the installation manual provided with the

appliance.

30" (76.2 cm) minimum clearance between the top of the cooking

surface and the bottom of an unprotected wood or metal cabinet; or If

30" (76.2 cm) clearance is not possible, minimum of 24" (61 cm) can be

used when the bottom of the wood or metal cabinet is protected by not

less than ¼" (0.64 cm) flame-retardant millboard covered with not less

than no. 28 MSG sheet steel, 0.015" (0.038 cm) stainless steel, 0.024"

(0.061 cm) aluminum, or 0.020" (0.051 cm) copper.

18" (45.7 cm) of minimum clearance between the countertop and the

adjacent cabinet bottom.

•

Exception 2 : For island installation, maintain 2½" minimum from cutout

to back edge of countertop and 4" minimum from cutout to side edges of

countertop.

Install_DOP36P86DLS_DG68-01106E-00_EN+MES+CFR.indb 13