Dacor DOP36P86DLS Manuel D'installation page 26

Installation instructions
Step 9. Install the anti-tip device
WARNING
• To reduce the risk of tipping, the appliance must be secured by properly
installing the anti-tip device packed with the appliance.
All ranges can tip, resulting in personal injury.
•
• Tipping ranges can cause burns from spills, personal injury, and/or death.
• To prevent accidental tipping, install and check the anti-tip bracket following
the instructions and template supplied with the bracket.
Anti-Tip Foot
(location varies)
Anti-tip
bracket
Anti-Tip Foot
26 English
Install_DOP36P86DLS_DG68-01106E-00_EN+MES+CFR.indb 26
An anti-tip bracket and screws, installation
instructions, and template are shipped with
every range (PN 114475). The instructions
include information necessary to complete
the installation of the anti-tip bracket. Read
and follow the instructions on the sheet
and use the template for anti-tip bracket
installation. If not properly installed, the
range could be tipped by you or a child
standing, sitting, or leaning on an open oven
door.
*approximatel
1 / " (35.1 mm)
3
8
Screw must enter wood or concrete
NOTE
To install the Anti-tip bracket, release the leveling leg using pipe wrench because
Loctite is applied on Bolt for vibration unlocking. A minimum clearance of 1
(35.1 mm) is required between the range bottom and the kitchen floor.
To check if the bracket is installed and engaged properly, remove the kick panel
and look underneath the range to see that the leveling leg is engaged in the
bracket. Carefully tip the range forward. The bracket should stop the range within
4 inches (10.2 cm) of tipping. If it does not, the bracket must be reinstalled.
If the range is pulled from the wall for any reason, always repeat this procedure
to verify the range is properly secured by the anti-tip bracket. Never completely
remove the leveling legs or the range will not be secured to the anti-tip device
properly.
Anti-Tip
bracket
/ "
3
8
2020-07-01 오후 3:44:10