Appliance Dimensions; Recess Dimensions - Atag KD80122AFN Instructions De Montage

The floor at the site must be flat and level.
q
Do not install the appliance in a location where it is exposed
q
to direct radiation of the sun, next to a cooker, heater and
similar.
Do not install the appliance alone: it is best to work together
q
with two or more people.
The more R 600a refrigerant there is in the appliance, the
q
larger the room in which the appliance is standing needs to
be. In rooms that are too small, a flammable mix of gas and
air may be created if there is a leak. According to the EN 378
standard, every 11 g of R 600a refrigerant requires at least
1 m space in the room for the appliance. The amount of
3
refrigerant in your appliance is on the type plate inside the
appliance.
If the appliance is installed in a very damp environment,
q
condensed water may form on the outside of the appliance.
Always make sure that there is good ventilation - both at air
inlet and outlet - at the site of installation.
u Pull off red transport lock.
After installation:
u Remove protective films, adhesive tapes and transport lock
parts etc.
Note
u Clean the appliance (see
Chapter "Cleaning the appliance").

4 Appliance dimensions

A (mm)
KD80102ADN 559
KD80122AFN 559
* Depending on model and options
Operating Instructions,
Fig. 1
B (mm) C (mm)
544 1022
544 1218
Appliance dimensions
A (mm)
KD80140AFN, 559
KD80140BFN,
KD80140CDN,
KD80140ADN
KD80178AFN, 559
KD80178CDN

5 Recess dimensions

The appliance is built-in and therefore completely enclosed by
a kitchen unit. The kitchen unit concerned must be built exactly
to the prescribed dimensions and allow for sufficient ventilation,
both at air inlet and outlet, to ensure proper appliance opera-
tion.
Fig. 2
D E
(mm (mm
) )
KD80102ADN 1024
—
1040
KD80122AFN 1220
—
1236
560
—
KD80140AFN, 1397
570
KD80140BFN, —
KD80140CDN, 1413
KD80140ADN
KD80178AFN, 1772
KD80178CDN —
1788
The specified energy consumption applies to a unit depth of
560 mm. The appliance will work properly at a unit depth of 550
mm, but at a slightly higher energy consumption.
u Check the wall thickness of the adjoining cabinets: it must
be min. 16 mm thick.
u Only install the appliance in robust, stable kitchen units.
Secure the units against tipping.
B (mm) C (mm)
544 1395
544 1770
F (mm) G H J
(mm (mm (mm
) ) )
min.
550,
min. min. max.
recom-
500 40 19
mended:
560
13