Information Codes - Samsung DMT800 Série Manuel D'utilisation

INFORMATION CODES

The Control Panel displays information codes to help you understand what is occurring with your
dishwasher. If you see any of the codes listed below, you should select the Cancel and Drain option, and
then follow the instructions in the Solution column.
CODE SYMBOL MEANING
For any codes not listed above, call 1-800-SAMSUNG (726-7864)
26_ troubleshooting
DMT800_DD68-00050A-05_EN_20120921.indd Sec7:26 DMT800_DD68-00050A-05_EN_20120921.indd Sec7:26
Temperature Sensor error
Heater error
High temperature Heating error
Low water level error
Half load function error
Water supply error
High temperature Water supply
error
Drain error
Over-level water error
Leakage
Button error
Communication Error
SOLUTION
Functional error. With the dishwasher empty, add
detergent, and then run a cycle.
If the problem continues, go to your house
circuit breaker panel, set the dishwasher's
circuit breaker switch to off, and then contact an
authorized Samsung service center.
Check whether the water supply valve is closed,
the water supply is suspended, or the water
inlet valve or line is frozen or clogged by foreign
particles.
If the problem continues, close the water supply
valve, and then contact an authorized Samsung
service center.
Check the temperature of the supplied water. If
it is higher than 176 ˚F (80 ˚C), a functional error
may occur with the dishwasher.
Check whether the drain hose is clogged or
folded. If the problem continues, close the water
supply valve, and then contact an authorized
Samsung service center.
Functional error. Close the water supply valve
and go to your house circuit breaker panel, set
the dishwasher's circuit breaker switch to off,
and then contact an authorized Samsung service
center.
Functional error. Turn off the dishwasher and try
to start it again.
If the problem continues, contact an authorized
Samsung service center.
2012-09-21 2012-09-21 2:09:31 2:09:31