Installation Of The Carbon Filter; Installation Of The Window Kit - Duux Blizzard Smart 12K Manuel D'utilisation

• Never leave a functioning device unsupervised.
• Do not pull the unit along by the cord.
• Avoid over-twisting, -coiling, -pulling the power
cord. Never use nylon or iron wire to tide the
power cord.
• Make sure that the plug and socket remain visible
and accessible at all the time.
• Do not use extension cords.
• Never reach to retrieve the unit if it has fallen in
water. In such case, immediately pull the plug
from the mains and have the unit checked before
using it again.
• If the supplied power cord is damaged it must be
replaced by an electrician or qualified person to
avoid any hazard.
• The mains supply must confirm to the
specification shown on the rating label on the
back of the device.
• The appliance shall be installed in accordance
with national wiring regulations.
• Do not exceed the recommended room size for
max. efficiency.
• Close doors and windows for optimal efficiency.
• Keep curtains or blinds closed during the
sunniest hours of the day.
• Keep filters clean.
• Once the room has reached the desired
conditions, reduce the setting for temperature
and ventilation.
• Do not turn on the device if you have discovered
damage to the appliance, cord or plug or if the
device is malfunctioning or if there are signs of
6
any other defect. Return the complete product to
the point of purchase or to a certified electrician
for inspection and/or repair. Always ask for
original parts. The device (incl. cord and plug)
may only be opened and/or repaired by properly
authorized and qualified persons.
• Only a licensed professional is allowed to
dismantle or modify the device.
• This device is to be used only for its prescribed
purpose. Any other use is deemed to be a
cause of misuse. The user/operator, not the
manufacturer will be liable for any damage or
injuries of any kind caused as a result of this.

Installation of the window kit

Blizzard is a portable air conditioner that may be
moved from room to room. Please refer to the
seperate instructions on how to install the included
window kit.
Mounting of the exhaust pipe
• Use only the hose provided and clip exhaust hose
to the back of the air conditioner
• Avoid kinks and bends in the exhaust hose as this
will cause expelled moist air to build up causing
the unit to overheat and shut down. Figures
below will show the correct position.
• The hose may be extended from 300mm to
1500mm but for maximum efficiency use the
shortest length possible.
Warning! The length of the exhaust pipe is
specially designed according to the specification of
this product. Do not replace or prolong it with your
own private hose as this could cause the unit to
malfunction.

Installation of the carbon filter

Remove the filter from the unit.
1
Remove the active carbon filter from its plastic
2
bag.
Insert the active carbon filter into the back of
3
the unit.
4 Re-fit the filter inside the unit.
Installation of the remote control
Remove the lid.
1
Place the battery according to the instructions
2
on the lid with the correct polarity.
Close the lid.
3
Note:
• Only use 1x CR2032 3V batteries
• Non-rechargeable batteries are not to be recharged
• Exhausted batteries are to be removed from the
remote control and safely disposed of
• If the remote control is to be stored unused for a
long period, the battery should be removed
• The supply terminals are not to be short-circuited.
7