Duux Blizzard Smart 12K Manuel D'utilisation page 6

Power switch
Press the ON/OFF button and the unit will start
1
automatically. If the ambient temperature is:
• Higher than 22⁰C, the unit will operate in
cooling mode.
• Higher than 20⁰C but below or equal to 22⁰C,
the unit will operate in ventilation mode.
Indicators of the functions in progress are
2
shown simultaneously.
Note: The display window shows the ambient
room temperature from 0⁰C to 50⁰C.
To turn the unit off, press ON/OFF button again
3
Select operation mode
Press the MODE button to select the preferred
operation mode: automatic, cooling, fan or
dehumidify. The indicator of your selected mode
will illuminate.
Setting the temperature
Press 'Temperature up' or 'Temperature down'
1
button to regulate the temperature according
to your preference.
The display window will show the desired
2
temperature as you press 'Temperature up' or
'Temperature down' button. In stand-by mode,
10
it will always show the ambient temperature.
The pre-set temperature of this machine is
3
24⁰C for cooling.
Adjusting the ventilation speed
Press the SPEED button to choose the
1
ventilation speed you prefer: high, medium
or low. The indicator of high, medium or low
ventilation will illuminate.
2 If the unit is in AUTO mode, it will choose the
ventilation speed automatically according
to the ambient temperature (the relevant
indicator will illuminate). When AUTO mode in
active, the SPEED button is disabled.
Setting the timer
Press the TIMER button to set a time-out (1 to
1
24 hours, the timer indicator will illuminate).
When the set time has been reached, the
machine will turn off automatically. The LCD
display will show the hour(s) you set as you
press the TIMER button.
By pressing the TIMER button without using the
2
other functions, you can activate a start delay.
For example, if you set the timer to '2', the unit
will automatically start after 2 hours.
Night mode
When pressing the NIGHT mode button in
1
cooling mode, the set temperature will increase
with 1⁰C after one hour, another 1⁰C after two
hours and then stays at that temperature.
In NIGHT mode, the ventilation will remain
2
at low speed. By pressing the NIGHT mode
button again, the temperature and ventilation
speed will return to the previous settings.
The unit will shut down automatically when
3
NIGHT mode is running for more than 12
hours.
Note: the night mode is not available while the
machine is operating in AUTO, Fan (ventilation) or
Dehumidification mode.
Note: In night mode, the display will
automatically dim after a few seconds. Press to
reactive the control panel.
Self-diagnosis
This machine is equipped with self-diagnosis
software. If the device is not working, the LCD
display will show "E1" or "E2". When this occurs,
please contact your point of purchase.
All the above functions can also be performed with
the supplied remote control. This remote control
requires a cell battery CR2032 to operate.
Note:
•To prolong the lifespan of the compressor, please
wait at least 3 minutes before re-switching on the
device after switching off.
• The cooling system will switch off if the ambient
temperature is lower than the set one. However, the
ventilation keeps operating on the set level. If the
ambient temperature rises above the selected level,
the cooling will return to work.
Drainage
During the process of cooling, some water will be
extracted from the air into the unit. If the reservoir
is full, both of the compressor and motor will
switch off and the units will buzz (press any button
to turn it off). The WATER FULL indicator will flash
to show you.
In this case, please empty the water by following
the steps below:
11