Wifi Mode - Duux Blizzard Smart 12K Manuel D'utilisation

Turn off the air conditioner and avoid moving it
1
when the water tank is full.
Put a container (a water tray for example)
2
underneath the drain hole.
Remove the drain knob & rubber plug from the
3
drain hole and allow the water to drain out.
When the container is almost full, close the
4
drain hole with the rubber plug and empty the
water tray.
Repeat until the unit is fully empty.
5
Replace the rubber plug andfirmly tighten the
6
drain knob.
Switch on the device - the full water indicator
7
should not be flashing anymore.
If you wish to operate the unit without the need to
empty the water tank (continuous drainage), please
follow these steps:
• Remove the drain knob and rubber plug and
retain for future use.
• Connect the drain tube supplied to the water
outlet as shown and locate the other end into a
drain.
• The drain tube may be extended by adding an
extension tube and using a suitable connector.
Note:
• The drain must be at or below the outlet level.
• The FULL WATER indicator will be disabled in this
mode of drainage.
12

WiFi mode

Press and hold the button for 5 seconds to
activate the WiFi mode. The indicator will flash and
start searching for devices to pair. Once connected,
the will turn solid.
WiFi and APP operation
Scan below QR code to download the Duux APP
or search DUUX APP in the App Store or Google
Play Store to start the procedure to download the
APP. Once installed, enter your e-mail address and
complete the registration.
APP STORE PLAY STORE
Connect to WiFi
Once registered, click "add duux device" on the
1
main screen or use the "+" button in the top
right corner to add a new device.,
Search for "Blizzard" and press to continue
2
Connect to your preferred WiFi network and
3
enter the corresponding password
Follow the instructions in the app to complete
4
the pairing process.
Note: if you experience any problems with
connecting or using the app, please refer to the FAQ
in the app menu.
13