Troubleshooting; T Characteristics; Maximum Specifications Of The Installable Camera With Lens - Videotec EXPT Série Manuel D'instructions

8 Troubleshooting

Although the EXPT P&T series is characterised by a great ease of use, sometimes troubles may occur,
especially during the installation and configuration phases or using the unit.
PROBLEM
Camera does not turn on
Camera turn on but there's
no video signal
P&T does not work
Lens does not work
Heater does not work
Image from camera is not
correct
Autopan does not work
9 P&T characteristics
Horizontal
Range
Speed
Torque
Vertical
Range
Speed
Torque
Dimensions (L x H x P, mm)
Inside housing dimensions (Ø x L, mm)
Bracket load rating
P&T weight
Bracket weight
Protection degree
Execution
Operating temperature
Power supply
Consumption

10 Maximum specifications of the installable camera with lens

Camera useful area (L x H x P, mm)
Max power
Max voltage
PROBABLE CAUSE
• No power supply
• Fuse blown
• Wrong connection
• Wrong P&T power supply
• Power supply not appropriate
• Lens power supply is not correct or
missing
• Thermostat is not set
• Wrong connection
• Wrong lens set
• Wrong camera working
• Wrong connection
• Wrong setting
360°
6°/s
2,5kgm
-90° ÷ + 90°
2,4°/s
6 kgm
570 x 407 x 640
Ø 180 x 380 (460 with glass protection device)
100 kg
55 kg (64 kg with glass protection device)
11 kg
IP 65
II 2 GD EExd IIC T6 T85°C IP 65 ATEX
Ex d IIC T6 Ex tD A21 T85°C IP 65 IECEx
-20°C ÷ + 50°C
-40°C ÷ + 50°C (Only for reinforced heater versions)
24V AC, 50/60 Hz
145 W total, excluded the internal camera
100 x 100 x 280 (360 with glass protection device)
20W
24V
Page 14
REMEDY
• Check the power cable
• Replace fuse
• Check connection cable
• Check P&T power supply
• Check power supply system
• Check lens power supply
• Check thermostat temperature
• Check connection cable
• Check lens set
• Replace the camera
• Check connection cable
• Check setting
MNVCEXPT_0702