Fiskars Fuse Creativity System Guide De Démarrage page 11

Die-cut Only
Follow these simple steps to die-cut in one pass through the Fuse Creativity System
Choose a Die
Make sure there is not a
letterpress plate in the die.
Make a Sandwich
Place crafting material on top
of the die.
Add the cutting plate, rubber
side down, on top of the
crafting material.
Tip: Printed names on the
cutting plates will always
face up.
One Pass Through
With one hand, gently push the
sandwich toward the rollers. With
other hand, turn the crank. Once
the sandwich is connecting with
the rollers, turn the crank to move
it through.
Tip: For easier loading, hold the
sandwich and lead with one corner
rather than the whole edge.
Slight popping or creaking as the
sandwich passes through the
machine is normal.
.
®
Final Step
Once the sandwich has
completely run through the
rollers, the finished result
can be accessed.
Tip: To remove finished
result, insert a cotton swab
into the hole located on the
bottom of the die.
11