Fiskars Fuse Creativity System Guide De Démarrage page 10

Die-cut + Press Only
Follow these simple steps to die-cut and press in one pass through the Fuse Creativity System
Choose a Die and
Letterpress Plate
Choose a letterpress
plate and place it in the
coordinating cutting die.
10
Make a Sandwich
Place crafting material on top of
the letterpress plate and die.
Add the cutting plate, rubber
side down, on top of the
crafting material.
Tip: Printed names on the
cutting plates will always
face up.
One Pass Through
With one hand, gently push the
sandwich toward the rollers. With
other hand, turn the crank. Once
the sandwich is connecting with
the rollers, turn the crank to move
it through.
Tip: For easier loading, hold the
sandwich and lead with one corner
rather than the whole edge.
Slight popping or creaking as the
sandwich passes through the
machine is normal.
.
®
Final Step
Once the sandwich has
completely run through the
rollers, the cutting plate can
be removed and the result
can be accessed. Place
the orange cover under
the die and press down —
the letterpress plate and
finished result will raise
and be easier to remove.