Sash Window Installations - Friedrich X-Star XQ05 Manuel D'installation Et D'opération

Sash window installations

Falling Object Hazard
Not following Installation Instructions
for mounting your air conditioner can
result in property damage, injury, or
death.
STEP 1 After removing the unit from shipping carton, remove tape holding
decorative front in place. Lay front in a safe out-of-the-way place, then
slide chassis out of cabinet (see Figure A).
STEP 2 Attach curtain assemblies to cabinet as shown in Figure B. Use eight
(8) No. 8 x " slotted hex head screws (item #1, page 6).
STEP 3 Center cabinet in window with sill channel positioned against
window stool as shown in Figure C, Section A-A.
STEP 4 Pull window sash down behind Shell Support Channel on top of
cabinet; this helps hold cabinet in place. Install No. 8 x " hex
head screw (item #3, page 6) in sill channel at bottom of window
opening as shown in Figure C.
STEP 5 Extend the sliding curtains on each side so the frames t into
the window channels. While holding the curtain frames in place,
mark four (4) hole locations (hole locations are in the upper
corners on left and right curtain assembly), two (2) in the
window jamb and two (2) in the window sash. Slip the curtains
back from marked locations and drill four (4)
holes. Again, extend the sliding curtains on each side and then
install two (2) no. 8 x ½" Phillips head screws (item #2, page 6)
and two (2) No. 8 x 1 ¼" Phillips head screws (item #4) through
the curtain frames as shown in Figure C.
Figure A
TO PULL UNIT FROM SLEEVE, USE PULL STRAP AND BASEPAN
HANDLE LOCATED ON FRONT. OBTAIN ASSISTANCE OR HELP
AS NECESSARY TO HOLD SLEEVE WHILE PULLING UNIT FROM
SLEEVE. MAKE SURE AIR CONDITIONER IS ON FIRM SUPPORT
BEFORE REMOVING UNIT FROM SLEEVE.
PULL STRAP
BASEP AN HANDLE
Figure C
SCREW, 1 1/4" PHILLIPS HEAD
(See illustration, item #4, page 6)
WARNING
7 / " diameter pilot
64
SCREW, 1/2" PHILLIPS HEAD
(See illustration, item #2, page 6)
SCREW, #8 x 7/8" HEX HEAD
(See illustration, item #3,
page 6)
WINDOW STOOL
920-197-01
Figure B
CURTAIN
ASSEMBLY
RETAINING
BRACKET
CURTAIN
ASSEMBLY
(LEFT)
SCREW #8 x " SLOTTED HEX HEAD
(ILLUSTRATION ON PAGE 6, ITEM #1)
8 REQUIRED (4 EACH SIDE). INSTALL
FROM INSIDE SLEEVE TO CURTAIN
ASSEMBLY RETAINING BRACKET
CAUTION
Excessive Weight Hazard
Use two or more people when
installing your air conditioner.
Failure to do so can result in
back or other injury.
WHEN CARRYING OR HANDLING UNIT, OBTAIN ASSISTANCE OR
HELP AS NECESSARY TO SUPPORT UNIT FROM BOTTOM (BASE
PAN), MAINTAINING CLEARANCE FROM ALL OBSTACLES.
SILL
CHANNEL
SECTION A-A
SHELL SUPPORT
CHANNEL
CURTAIN
ASSEMBLY
(RIGHT)
CAUTION
Cut/Sever
Although great care has been
taken to minimize sharp edges
in the construction of your unit,
use gloves or other hand
protection when handling unit.
Failure to do so can result in minor
to moderate personal injury.
SHELL SUPPORT CHANNEL
WINDOW SASH
CABINET
7