Safety Instructions - BEHAbelt RS02 Mode D'emploi

2.3 SAFETY INSTRUCTIONS

If the safety of the operator can no longer be guaranteed, the appliance must be
taken out of operation and secured against unintended use. This is the case if the
appliance:
displays obvious damage
no longer performs the desired functions
was stored for too long under unfavourable conditions
was subject during transport to mechanical strains.
During the welding process melted welding material can be thrown out of the
machine. While operating the machine it is essential to wear safety glasses and
protective long-sleeved clothes (danger of burns).
Use the machine only in large and / or ventilated areas.
Switch on the machine only when belt profi le is clamped, otherwise the clamping
jaws can be thrown out of the holder.
Never use the product in an explosive area.
Never use the product in a wet area. Avoid the contact to the device directly with
water.
Repairs should only be performed by trained persons. Please send the product to
an authorized BEHAbelt service partner or directly to BEHAbelt.
This machine is not designed for continuous operation. Risk of motor over heating
and damaging of the machine.
1
For all work, the applicable accident
prevention regulations of the professional
association must be observed.
The friction welding machine RS02 may
only be held on the handles provided for
this. Touching the welding head during
operation must be avoided at all costs.
(see picture 1)
The appliance may only be connected to
the input voltage specifi ed on the name-
plate.
15