Service / Maintenance; Preventive Maintenance; Repair - BEHAbelt RS02 Mode D'emploi

General:
large profiles from Ø 12
small profiles < Ø 12
Switch on the machine (3) Important: only with clamped profile, risk of voiding
parts (profile jaws)!
After reaching the max. Speed of the motor by pressing the release button (7)
fusion process (welding jaws move together).
When profile swells up, switch off the machine (3)
Welding process is finished
Leave profile clamped for 2-3 min. in the machine to cool off.
Allow to cool profile after removal for about another 10 minutes before the weld is
loaded.
First, open the hex head bolt (11) to take out the profiles. Then move apart with the
external hex (5) the sealing jaws to facilitate the removal of the profile.
Now the next welding process can be performed.

3 SERVICE / MAINTENANCE

3.1 PREVENTIVE MAINTENANCE

To work effectively and surely keep the machine and the ventilation slots clean at all
times.
After operating for about 150 hours, the AC motor could be cleaned, inspected, and,
if necessary, replaced by an authorised BEHAbelt customer service centre.

3.2 REPAIR

If despite strict observance of the manufacturing and testing method the machine
should happen to fail, it must be repaired by an authorized BEHA belt agency.
Any replacement needed for the connecting line must be installed by the manufac-
turer or its agent if safety risks are to be eliminated.
Full set pressure (8)
Half set pressure (8)
17