Work Sequence - BEHAbelt RS02 Mode D'emploi

2.4 WORK SEQUENCE

Please note the safety instructions and warnings on point 2.3!
Select and insert the clamping jaws (9). Remove adapter (10) for customised
profiles if required and insert the customised clamping jaws.
Driving jaws (9) apart and rotate the external hex (5) with a key to the left until the
clamping equipment engages.
Cut off both ends of the profile to be connected.
Insert the profile in the middle of the clamping jaws (9) and hold it tight with the
centre lever (6). Tighten the hexagonal head bolt (11) with the hexagonal socket
wrench. Repeat process for other side.
Between the two ends profile now should still minimal welding gap (light gap).
Warning: It is not necessary to tighten the tension bolts to the full stop point when
fastening belts in the RS02 welder. Only tighten the tension bolts as required
to prevent belt slippage in the jaws. Over tightening can cause damage to the
tension bolts and cause the material to deflect.
Note for the welding of small profiles: Clamp profile in the fixed clamping jaw with
only 2 mm supernatant Clamp other end of the profile in the oscillating jaw with
only 3 mm supernatant. Do not crush profile so that a planar friction surface as
possible is preserved.
Set the speed regulator (2) (steps 1 - 6) depending on the profile to be welded.
Small profiles step 4 - 6; depending on PU quality, large profiles step 5-6.
Set the contact pressure on adjustment knob (8).
Heavily depressed position
slightly depressed position
16
STOP
full pressure
half pressure