Set-Up - Grindmaster RC400 Manuel D'instructions

Set-Up

Priming the internal heating tank
NOTE: The brewer will not operate until the hot water
tank is primed.
Please follow these procedures to ensure proper
installation.
Pour Over version
1. Ensure that the water inlet valve cap supplied
with the machine is installed on the water inlet
valve to prevent leaking.
2. Open reservoir lid.
3. Fill reservoir with tap or bottled water to the
level indicated on reservoir. Do not use
distilled water.
4. Plug unit into a 120V/15 amp receptacle. Turn
main power switch to ON.
5. Place a cup in the drip tray of the unit to collect
the water from the priming operation.
6. The screen will display "Prime Brewer". Press and
release BREW button.
7. Refill the reservoir to the appropriate level.
8. Allow brewer to reach brewing temperature.
Auto-Fill version
1. Plumb water to the fill valve located on the back
of the brewer. A ¼" female flare x ¼" tube
adapter and a ¼" flare x hose adapter are
provided with the brewer. Do not use reverse
osmosis water.
2. Fill reservoir with tap or bottled water to the
level indicated on reservoir. Do not use distilled
water.
3. Open water service valve.
4. Plug unit into a 120V/15 amp receptacle. Turn
main power switch to ON.
5. Place a cup in the drip tray of the unit to collect
the water from the priming operation.
6. The screen will display "Prime Brewer". Press and
release BREW button.
7. Allow brewer to reach brewing temperature.
Note: Auto-Fill ONLY
The water is supplied directly to the unit and the
water fill level marking is not used. Fill level will vary
depending on water pressure. Normal refill level will
be below "MAX" line.
Fill Level
Model RC400
Set Point Temperature Adjustment
Enter the settings screen by touching the setting icon
( ) on the main screen. Then press the lock icon ( ) at
the lower right to access the advanced settings screen.
Enter code. (Default pass code is 0400). Select Water
Temperature and adjust using up and down arrows to
desired temperature. Unit is factory set at 195˚F
(90.6˚C).
Recommended
Set Point
°F (°C)
200 (93)
198 (92)
196 (91)
195 (90)
193 (89)
191 (88)
189 (87)
187 (86)
185 (85)
Grindmaster ®
Elevation
City
ft. (M)
0
1000 (305)
2000 (610)
3000 (915) Calgary
4000 (1219)
5000 (1524) Denver/Albuquerque
6000 (1828) Colorado Springs
7000 (2134) Santa Fe
8000 (2438)
ENGLISH 7