Grindmaster RC400 Manuel D'instructions page 3

Safety Information (continued)
DANGER
To prevent the possibility of electrocution, burns, or other injuries and to prevent damage to your brewer, do
not immerse in water or any cleaning liquids.
Do not operate a damaged brewer. Inspect the power supply cord and water supply often. If cord or plug is
damaged or worn, do not use your brewer. Turn off the water supply and disconnect the electrical power.
Turn off and unplug the brewer before cleaning or maintenance.
Risk of suffocation. The product packaging contains a plastic bag. Keep plastic bags away from children.
Disconnect power if the machine functions abnormally and notify qualified service personnel for repairs. Do
not permit non-qualified service personnel to attempt repairs. There are no user serviceable components inside
the brewer. Do not disassemble the brewer.
WARNING
The brewer must only be connected to a three wire 120 VAC, 60 Hz, 15 Amp, electrical circuit.
CAUTION
For indoor use only. Do not install or use outdoors, in moving equipment, or watercraft.
Use the product for its intended purpose only. Any other usage is inappropriate and may be dangerous. The
manufacturer assumes no responsibility for injury, loss, or damage resulting from improper machine use.
Brew probes are sharp. To prevent injury, do not place fingers inside the brew chamber.
Risk of burns. The brewer uses 185°F- 200°F water that, if not properly handled, could cause burns. Do not permit
children to use this appliance unless there is direct adult supervision. Keep away from pets and other animals.
To avoid the risk of burns, do not operate without bezel installed.
Allow brewer to cool before cleaning or maintaining.
Hot surfaces may cause burns. Do not touch the brewer while in operation.
To prevent scalding by hot water, do not open brew chamber while brewing.
To prevent scalding by hot water, do not move or tilt the brewer. Moving or tilting the brewer could result in
water spilling from the reservoir. Internal boiling is possible at high elevations. You must reduce temperature
set point below boiling point for your elevation.
To avoid scalding, use appropriate cup rest to minimize splash. Allow a minimum of 1/2" clearance between cup
rim and brewer dispense spout to prevent spills when removing a full cup. Center cup with dispense spout while
brewing and allow brewer cycle to complete before opening brew chamber or removing cup.
To avoid pinching, keep fingers clear of brew chamber when closing.
NOTICE
For best results, remove used Real Cup™ capsule from brew chamber after each brew is complete.
Avoid spills by not removing the reservoir while Auto-Fill unit is filling; allow filling to complete before removing
reservoir.
A qualified professional should perform installation, maintenance and repairs.
Installation, maintenance or repairs by unqualified personnel may damage the brewer and void the
manufacturer's warranty.
This equipment must be installed in accordance with the appropriate national and local codes of the country
and/or region in which the appliance is installed.
Contact the manufacturer to report any malfunction or damage to the brewer.
When turning the machine off for an extended period, be sure to evacuate the water inside the brewer
completely; otherwise the water inside the machine could freeze and lead to damage or cause mold to appear.
To reduce foreign material from entering the brewer, keep brew chamber and reservoir lids closed.
To prevent accidental overfilling of cup, press "BREW" to stop.
Model RC400 Grindmaster ® ENGLISH 3