Lawn Edge Trimming; Cleaning And Maintenance; Cleaning; General Maintenance - Grizzly Tools CT 2000 Li Traduction De La Notice D'utilisation Originale

GB

Lawn edge trimming

Setup for edge trimming:
To trim lawn edges, slowly move the appli-
ance along the lawn edges.
• Handle rod: 180° (see
• Cutting angle position 5
ƒ
(see )
• Spacer bow in parking position
Cleaning and
maintenance
Warning! Risk of injury from
moving dangerous parts!
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance with
water and do not immerse it in
water. Electric shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush. Do not
use cleaning agents or solvents. You
may otherwise irreparably damage the
appliance.
• After every trimming session, remove
grass and soil from the protective
cover and the trimming assembly.
64

General maintenance

•
„
)
•
1. Slide the cutting insert (13) inward and
2. Place the new cutting insert (13) on

Storage

•
•
Disposal and protection
of the environment
Remove the battery from the device and
take the device, battery, accessories and
packaging for environmentally friendly
recycling.
Prior to every use, check the appli-
ance for obvious defects such as
loose, worn or damaged parts. Ensure
that the screws in the cutting device
are firmly in place.
Check covers and safety devices for
damages and correct installation. Re-
place as necessary.
Replacing the cutting
insert
push it out of the pin (23) on the cut-
ting disk (12).
the pin (23) and pull out the insert until
it snaps in.
Store the trimmer in a dry place well
out of reach of children.
Do not stand the trimmer on its pro-
tective cover. Suspend it by its upper
handle in such a manner that the pro-
tective cover does not come into con-
tact with other objects. This is because
the protective cover could become
deformed, thereby changing its dimen-
sions and its safety properties.
Machines do not belong with do-
mestic waste.