Tuning To Radio Stations - Philips AZ 1145 Mode D'emploi

Masquer les pouces Voir aussi pour AZ 1145:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TUNING TO RADIO STATIONS

1. Select TUNER source.
is displayed briefly and then the radio station
frequency is shown.
2. Press BAND once or more to select your waveband.
3. Press ∞ or § on the set or on the remote control and release
when the frequency in the display starts running.
™ The tuner automatically tunes to a station of sufficient
reception. Display shows
™ If an FM station is received in stereo,
4. Repeat step 3 if necessary until you find the desired station.
• To tune to a weak station, press ∞ or § briefly and
repeatedly until you have found optimal reception.
5. Adjust the power slider to TAPE/
set.
To improve radio reception
– For FM, pull out the telescopic antenna. Incline and turn the
antenna. Reduce its length if the signal is too strong (very
close to a transmitter).
– For AM, the set is provided with a built-in antenna so the
telescopic antenna is not needed. Direct the antenna by
turning the whole set.
Favorite station selection
For your favorite 3 tuner stations, you can use the easy one-touch
programming and selection 1, 2 or 3 buttons.
1. Tune to your desired station (see Tuning to radio stations).
2. To store your station, press 1, 2 or 3 for 2 seconds or more.
™ Display: shows
PROGRAM
number and the tuner frequency.
Programming radio stations
You can store up to a total of 30 radio stations in the memory.
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROGRAM to activate programming.
– Display:
flashes.
PROGRAM
3. Press PRESET 4 or 3 once or more to allocate a number from
1 to 30 to this station.
4. Press PROGRAM again to confirm the setting.
– Display:
disappears, the preset number and the
PROGRAM
frequency of the preset station are shown.
5. Repeat the above four steps to store other stations.
– You can overwrite a preset station by storing another
frequency in its place.
Tuning to preset stations
Press 1, 2, 3 or PRESET 4 or 3 until the desired preset station is
displayed.
during automatic tuning.
is shown.
STEREO
position to switch off the
OFF
briefly, your favorite preset station
DIGITAL TUNER
TUNER
STEREO
FM
11

Publicité

Table des Matières
loading

Table des Matières