Basic Functions; General Maintenance; Safety Information; General Information - Philips AZ 1145 Mode D'emploi

Masquer les pouces Voir aussi pour AZ 1145:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BASIC FUNCTIONS

Switching on and off
• Adjust the POWER slider to the desired sound source:
CD, TUNER or TAPE/
• The set is switched off when the POWER slider is in the
TAPE/
position and the keys on the tape deck are released.
OFF
™ The volume and tuner presets will be retained in the set's
memory.
Adjusting volume and sound
1. Press the VOL +, – controls to increase or decrease VOLUME
(or press 3 or 4 on the remote control).
2. Adjust the DBB control to select dynamic bass boost on or off.
PHILIPS demo mode
1. On the set, press the CD STOP 9 button for 5 seconds.
™ PH..IL ..IPS scrolls across the display continuously.
2. To return to the current display you can either:
• press any function button on the front panel. This interrupts
the demo mode for 30 seconds;
• press the CD STOP 9 button for 5 seconds. PH..IL ..IPS
scrolls once before the demo mode is cancelled.

GENERAL INFORMATION

General maintenance

• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing.

Safety information

• Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
10
.
OFF
GENERAL INFORMATION

Publicité

Table des Matières
loading

Table des Matières