Semi-Universal Installation In The Vehicle With K-Fix - KIDDY cruiserfix3 Guide D'utilisation

6 Semi-universal installation in the vehicle with k-fix +

Actuate the unlocking handle (R)at the front underneath the leg extension (K)
(Fig. 7, No. 1). The k-fix
back of the seat (I).
Rotate the connectors (E) 180° such that the connection openings point
towards the vehicle seat (Fig. 8).
Check whether the connector hooks are open by sliding the two unlocking
mechanisms (S) forward. If the locking indicators (T) do not show 'green' , the
connector hooks are open (Fig. 14).
Place the Cruiserfix 3 in a vehicle seat location which allows
!
for semi-universal installation (point 5.3) and adjust the vehicle
seat as necessary according to point 5.1.
Now slide both k-fix
points) and push firmly against them such that the connectors (E) lock in place
(Fig. 10).
The correct engagement is confirmed with the 'green' k-fix
(T) (Fig. 11).
Check whether the k-fix + connectors (E) are closed by shaking
!
the seat (I) and check whether the lock indicators (N) on the left
and right k-fix + connectors both show 'green'!
As a final installation step you need to slide the child restraint system (A) toward
the backrest of the car seat.
Keep the release button (R) pressed in (Fig. 12; Point 1) while at the same time
pushing the seat (I) toward the backrest (Fig. 12; Point 2).
After installing the child restraint system (A) with k-fix
seat is positioned on the vehicle seat and the belt is not covered. For this purpose,
you can slide the seat slightly to the left or right as necessary.
+
connectors (E) now automatically extend out of the
+
connectors (E) onto the metal mounts (ISOFIX anchorage
+
23
EN
+
locking indicator
, ensure that the child