Philips PT937 Mode D'emploi page 12

ENGLISH
12
3
1
2
2
1
3 Place the shaver in the holder (1), tilt the shaver backwards (2)
and press down the top cap to connect the shaver ('click') (3).
The battery symbol and the on/off button start to lash,
,
which indicates that the shaver is being charged.
4 Press the on/off button on the SmartClean system to start the
rinsing phase.
, The on/off button and the rinsing symbol both light up continuously.
Note: The rinsing phase takes approx. 10 minutes.
, When the cleaning program has been completed, the ready symbol
lights up continuously.
The battery symbol lights up continuously to indicate that the shaver
,
is fully charged.
Note: Charging takes approx. 1 hour.
Note: If you press the on/off button of the SmartClean system during the
rinsing phase, the program aborts. In this case, the rinsing symbol stops
lashing.
Note: If you remove the adapter from the wall socket during the rinsing phase,
the phase aborts.
Note: 30 minutes after the rinsing phase and charging have been completed,
the SmartClean switches off automatically.
5 To let the shaver dry, you can leave it in the SmartClean system
until your next shave. You can also remove the shaver from the
SmartClean system, shake off excess water, open the shaving unit and
let the shaver air dry.
Replacing the cartridge of the SmartClean System
Replace the cleaning cartridge when the replacement symbol lashes
-
orange or when you are no longer satisied with the result.
1 Press the button on the side of the SmartClean system (1) and lift
the top part of the SmartClean system (2).