Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Problem
The sensor fields become hot.
comes on.
comes on.
comes on.
and a number come on.
comes on.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on.
INSTALLATION INSTRUCTIONS
Warning! Refer to "Safety information"
chapter.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
Possible cause
The cookware is too large or
you put it too near to the con-
trols.
The Automatic Switch Off op-
erates.
The Child Safety Device or the
Lock function operates.
No cookware is on the cook-
ing zone.
The cookware is incorrect.
The diameter of the bottom of
the cookware is too small for
the cooking zone.
There is an error in the appli-
ance.
There is an error in the appli-
ance because a cookware
boils dry. The overheating pro-
tection for the cooking zones
and the Automatic Switch Off
operate.
Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer
service technician or dealer will not be free
of charge, also during the warranty period.
The instructions about the customer service
and conditions of guarantee are in the guar-
antee booklet.
• Model ...........................
• PNC .............................
• Serial number ....................
Built-in appliances
• Only use the built-in appliances after you
assemble the appliance into correct built-
in units and work surfaces that align to
the standards.
Remedy
Put large cookware on the rear
cooking zones if necessary.
Deactivate the appliance and
activate it again.
Refer to the chapter "Daily Use".
Put cookware on the cooking
zone.
Use the correct cookware.
Move cookware to a smaller
cooking zone.
Disconnect the appliance from
the electrical supply for some
time. Disconnect the fuse from
the electrical system of the
house. Connect it again. If
comes on again, speak to the
service centre.
Deactivate the appliance. Re-
move the hot cookware. After,
approximately 30 seconds, acti-
vate the cooking zone again. If
the cookware was the problem,
the error message goes out of
the display, but the residual
heat indicator can stay. Let the
cookware become sufficiently
cool and refer to "Cookware for
the induction cooking zone" to
see if your cookware is compat-
ible with the appliance.
leonard 25
Publicité
Chapitres
Table des Matières
