Removing And Replacing The Warming Drawer - Samsung NE59 785 Série Manuel De L'utilisateur

Maintaining your appliance
How to replace the door
You can replace the upper door the same way you replace the full door
(NE59*785***).
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal position, slide the indentation
of the hinge arm into the bottom edge of the hinge slot. The notch in the
hinge arm must be fully inserted into the bottom of the slot.
Hinge
arm
Bottom
edge of
slot
Indentation
3. Open the door fully. If the door will not open fully, the indentation is not
inserted correctly in the bottom edge of the slot.
4. Push the hinge locks up against the front frame of the oven cavity into the
locked position.
5. Close the oven door.
46 English
Hinge lock
Unlocked position Locked position

Removing and replacing the warming drawer

CAUTION
Turn the power OFF before removing the warming drawer.
How to remove the warming drawer
1. Pull out the drawer until it stops.
2. Locate the locking clips near the back of each full-extension roller guide rail.
Using two hands, push down on the left clip and lift up on the right clip to
release the clips. Pull the drawer the rest of the way out.
Lever
Push down on the
left guide
3. Pull the warming drawer away from the range.
How to replace the warming drawer
Right roller guide rail
Lever
Pull up on the right
guide
1. Position the ends of the full-extension
roller guide rails in the side rails of the
drawer opening.
2. Push in the drawer to close it and snap
the locking clips into place.