Run; Stop; Cleaning; Attachment Use - Stiga Park 4WD Série Manuel D'utilisation

(Translation of the original instructions)
Cold start
For 2WD models
1. Put into gear (14:A1).
For 4WD models
1. Put into gear (15:A1-B1).
2. Engage the parking brake (10:B)
3. Move the accelerator to full throttle (11:A; 12:A).
4. Close the choke (12:B1) (if applicable).
5. Turn the ignition key and start the engine.
Before operating the machine, wait a
few minutes to allow the oil to heat up.
Hot start
For 2WD models
1. Put into gear (14:A1).
For 4WD models
1. Put into gear (15:A1-B1).
Engage the parking brake (10:B)
2.
3. Move the accelerator to full throttle (11:A; 12:A).
4. The choke control must be pressed (12:B2) (if
applicable).
5. Turn the ignition key and start the engine.
To continue see the instructions given
in paragraph 7.7.1.

7.7.1 Run

To operate with the machine proceed as de-
scribed below:
• Fully press the pedal down (10:B) and release
it.
• Press the pedal (10:F) to drive the machine.
• Move to the work area.
• If front attachments are installed, activate the
power socket (11:D, 12:D).
• Start work.
7.8

STOP

Proceed as described below to stop the machine:
• Disconnect the power socket (11:D; 12:D).
• Engage the parking brake (10:B)
• Let the engine run at minimum for one or two
minutes.
• Turn of the engine by turning the key.
• Close the fuel stopcock. This indication is
particularly important if the machine is to be
transported on a trailer or similar.
ENGLISH
If you have to leave the machine un-
attended, disconnect the spark plug
leads and remove the ignition key.
The engine could be very hot immedi-
ately after switching off. Do not touch
the muffler, the engine or the cooling
fins. This can cause burn injuries.
7.9

CLEANING

To reduce the risk of fire, make sure
there are no grass, leaves and oil on
the engine, muffler, battery and fuel
tank
To reduce the risk of fire, regularly
check the machine for oil and/or fuel
leaks.
Never use high pressure jets of water.
It could damage shaft seals, electrical
components and hydraulic valves.
Always clean the machine after use. Follow the
instructions below to clean:
• Do not spray water directly on the engine.
• Clean the engine with a brush and/or
compressed air.
• Clean the engine cooling air intake.
• After washing with water, start the machine
and the cutting device to remove any excess
water that could penetrate the bearings and
cause damage.

8 ATTACHMENT USE

Check that there are no foreign bodies
such as stones, etc. in the grass to be
cut.
8.1

CUTTING HEIGHT

For best results, cut one third of the height of the
grass. See fig. 23.
If the grass is long and needs to be cut signif-
icantly, mow twice using two different cutting
heights.
Do not use the minimum cutting height if the
surface is uneven.
The cutting devices could be damaged by hitting
the surface, undermining the top layer of the
lawn.
8.2

MOWING TIPS

EN
17