ACDelco ARM601-3 Mode D'emploi page 10

WARNING
side shields. Always remove battery pack before changing accessories or making
adjustments.
POWER ON
Press and release the Power Button (13) to turn the digital torque tool on.
ZERO FUNCTION
When powers on, the digital torque tool can be zeroed at measure mode by press and
release the Power Button (13).
NOTE
Do not zero at the torque is applying on the digital torque tool.
HOW TO SET PEAK MODE OR TRACE MODE
Press and release the Down Button (15) or Up Button (14) to select the mode you need.
TRACE MODE: When in track mode the wrench will display real-time torque.
PEAK MODE: When in peak mode the wrench will hold the highest measured
reading on the display until "zero-clear" by pressing and releasing the Power button
(13).
HOW TO SELECT UNIT
1. Press the Setting Button (16) more than 2 seconds to Set Mode.
2. When you see the digits start blinking, press the Setting Button (16) again to select
the desired measuring unit.
3. When the desired measuring unit is displayed, press the Setting Button (16) 2
seconds to confirm your selection. (or wait for 5 seconds the system will
automatically confirm your selection)
SETTING TORQUE ALARM VALUE
1. Press the Setting Button (16) more than 2 seconds to Set Mode.
1English1
OPERATION
To reduce the risk of injury, wear safety goggles or glasses with
English -9