Table des Matières
Publicité
How to bind
Please read these instructions carefully and keep
them in a safe place for later reference.
3C Punch pages by pulling handle down.
Then lift the handle back to the vertical position and
remove the punched sheets.
Note: To prevent jams do not attempt to punch more
than two cover sheets at a time.
3D Assemble pages onto open comb.
Remove the sheets from the punch slot and insert onto the
fi ngers of the binding comb.
3E Repeat process as required.
Repeat stages 3B-C-D until your document is fully loaded
on the comb.
CLOSE
Close comb and remove document.
ZipComb Spine
The ZipComb spine allows you to create an easily
editable document with comb punch orientation.
1 Place the spine into the zip holder as shown.
2 Load and punch paper as per 'How to bind' section
3E.
3 Load punched paper on to spine.
4 Remove document and spine, close the ZipComb
using the zipper included in the ZipComb boxes.
5 Complete by fl ipping the back cover around the
spine, for a professional fi nish where the spine is
hidden.
Publicité
Table des Matières
