Table des Matières
Publicité
How to bind
Please read these instructions carefully and keep
them in a safe place for later reference.
1A Measure document using color coded
guide.
Open the lid of the machine and rest your document
(including any cover sheets you have chosen) against the lid
on the 'staging' area provided. Gently push the document
back against the lid and check the document size using the
color coded guide on the staging area. You can leave your
document on the staging area in readiness to punch.
1B Select comb which fi ts your document.
Use the comb size guide to select the size of comb that fi ts
your document i.e. 25 sheet document = ¼" comb.
2A Load comb onto machine.
Insert the binding comb next to the white positional arrow
on the machine, behind the metal comb support fi ngers,
with the open side of the comb pointing upwards.
2B Open comb by turning lever towards you.
The colored arrows adjacent to the opening comb act as
a guide as to how far to open in order to allow punched
sheets to be easily inserted.
3A Select document size.
Adjust the edge guide button to select the paper / cover
size you wish to bind; Letter (8 ½"x 11") or A4 (297mm x
210mm). When using oversized covers, select the oversize
position, punch the covers for your document and set aside.
Then select either Letter or A4 and proceed.
3B Load pages into slot. You can punch 2
cover sheets or up to 20 sheets of paper
(20lb./80gsm) at a time.
Using the conventional method: Select the quantity of sheets to
punch and tap the edge of the sheet stack against the staging area
to ensure that all sheets are aligned. Place the stack to be punched
directly into the punching slot and slide to the left until it comes to rest
against the edge guide. Your sheets will now be perfectly aligned. Let
go of the sheets and grasp the punch handle with both hands.
Using the gravity fed paper count method for increased
productivity: Pull forward your document (or a stack of sheets from
your document) from its resting position against the lid. Continue
until it meets the wall in front of the punch slot. Relax your grip on
the document or stack and the fi rst 20 sheets will fall directly into the
punching slot. Return the sheets not engaged in the punch slot back
to a resting position against the lid. Slide the sheets in the punching
slot to the left as far as they will go. Your sheets will now be perfectly
aligned. Let go of the sheets and grasp the punch handle with both
hands.
Publicité
Table des Matières
