Wolfcraft 5019000 Traduction De La Notice D'utilisation Originale page 10

• Always use the protective cover (8).
• Only use the cutting stand with an angle grinder which is equipped with the suitable metal protective
cover around the cutting disc.
• Position this protective cover so that the cutting disc runs freely in the open part and so that
the protective cap is unable to make contact with the work piece.
• Cutting work generates sparks. Ensure that no flammable materials are in the working area. Sparks
can damage paint, glass and other surfaces. Do not wear any nylon or polyester clothing,
but suitable non-flammable work clothes.
• Ensure that the mains cable does not protrude into the working area of the disc or where sparks
are flying. Always insert the mains cable of the angle grinder in the cable holder (12).
• Ensure that the work piece is correctly fixed in position between the two clamping jaws and is firmly
positioned on the base plate.
• Do not use work pieces which are too large to be fixed in position between the two clamping jaws.
• Store the cutting stand in a dust-free and dry place.
• Regularly inspect the firm seating of all of the screws before and during use. Regularly inspect the stand
for signs of damage. Screws can become loose during use due to vibration. Do not use the cutting
stand if you detect any damage.
• Ensure that the cutting disc of your angle grinder is mounted perpendicular to the base plate.
• Only use cutting discs and no roughing discs.
• Always remove the plug of your angle grinder from the socket before carrying out any cleaning
or adjustment work on your cutting stand.
• Never place you hand in the working area of the cutting disc.
• Always observe the cutting depths as there is otherwise the risk of damaging your workbench.
• Always remove the plug when not using the stand.
• Positioning the machine improperly or positioning the cutting disc on the workpiece too quickly
can cause the disc to shatter. RISK OF INJURY!
• CAUTION! The cutting stand and machine must never be used in the presence of moisture.
Risk of electric shock!
• Fastening the disc improperly can cause it to become loose during operation. RISK OF INJURY!
• Never remove the workpiece while the machine is running. RISK OF INJURY!
• Never make any technical modifications of your own to the cutting stand.
• Do not use cutting discs with an expired use-by date.
• Always remove cuttings from the work and danger area.
• Keep yourself and persons in the vicinity outside of the plane of the rotating grinding wheel.
• Only use bonded, reinforced or diamond-studded cutting discs for your power tool, which are suitable
and intended for the power tool.
• The permissible speed of the tool used must be at least as high as the maximum speed specified
on the power tool.
• Grinding stones may only be used for the recommended applications. For example: Never grind using
the side surface of a cutting disc.
Safety information for parting grinders
t
10