Empire Comfort Systems FRBTPL-1 Instructions D'installation page 6

Sleep Function
The SLEEP function allows you to set a countdown period of eight
hours in 15 minute increments, at the end of which the unit will
shut down.
1. To activate the SLEEP function, press the Menu button twice.
The sleep symbol
that you are in the sleep timer setting menu. See Figure 16.
2. The figures 00:00 appear in place of the current time. Use the
up and down button to set the countdown time. Press arrow
up to increase the countdown setting, or press arrow down to
decrease the countdown setting. See Figure 16.
3. To confirm the setting and exit the sleep setting menu, press
the menu button twice more. See Figure 16.
When you exit the SLEEP setting menu, the display shows
the sleep symbol as an outline and the countdown time to unit
shut-down instead of current time.
NOTE: If the keypad is not used for 7 seconds, the remote con-
trol automatically exits the sleep setting menu and assumes the
last settings entered.
4.
To deactivate sleep mode, press the mode button twice to
enter the sleep setting menu. The sleep symbol
appear. Use the up and down button to set the countdown
setting to O.
5. Wait seven seconds or press the menu button twice to confirm
the setting. Sleep mode is now deactivated, and the sleep
symbol will be gone.
SETTING A WEEKLY PROGRAM
The remote control 10 preset weekly operating programs. These
programs will cycle the remote thermostatic mode on and off at
different times throughout the week. See Table 1.
1. To select a weekly program press the menu button twice to
enter the program menu until the timer symbol
pears on the display. See Figure 17.
2. You can now use the up and down button to select one of ten
preset weekly programs in the remote control. See Figure 17
Refer to Table 1 to choose the program that best suits your
home's heating requirements and select its number on the
remote control.
Page 6
will appear on the screen indicating
Figure 16
NOTE: If the keypad is not used for seven seconds, the remote
control automatically exits the program menu and assumes the
last settings entered in the program menu.
3. Press the menu button again to confirm your choice and exit
the program menu. See Figure 17. The CLOCK symbol
remains displayed in outline on the remote control screen.
When the outlined clock symbol is displayed, a program is ac-
tive and the unit will be started up and shut down at set times
ever day of the week.
IMPORTANT! When program mode is active, the clock
symbol
control. PROGRAM mode can be activated/deactivated
with the unit functioning or shut down.
NOTE: You can start up or shut down the unit manually even if
a program is active. Manual commands take precedence over
program commands. The next program command will be ig-
nored.
Example: if the timer is due to start the unit at 10:00, but you al-
ready feel cold at 9:00 and want to start the unit up early, press
the up and down button. The command to start the unit at 10:00
will then be ignored because the unit will already be functioning.
will
4. To deactivate PROGRAM mode, press the menu button
twice to enter the program setting menu. The clock symbol
will appear.
5. Use the up and down button to select "OFF."
6. Wait seven seconds or press the menu button again to con-
firm the setting. Program mode is now deactivated, and the
clock symbol will be gone.
ap-
Figure 17
is displayed on all screens of the remote
37855-0-0117