Empire Comfort Systems FRBTPL-1 Instructions D'installation page 2

2
13
15
14
16
1
MAN
AUTO
PILOT
3
4
INDEX
NO.
Remote function mode symbols
MAN - Indicates the remote is in Manual mode
1
AUTO - Indicates the remote is in Thermostatic mode
PILOT - Indicates the remote is in Standby mode
2 Symbol for remote communication to unit
Keypad lock symbol. This symbol appears when keypad is
3
locked.
Low battery symbol. When this symbol appears without
4
flashing, the batteries must be replaced.
The temperature currently measured by the remote con-
5
trol's built-in sensor for the area around the remote control.
Temperature units of measurement
6
(Celsius - Fahrenheit).
Symbol identifying room temperature measured by the
7
built-in sensor.
The thermostatic mode set temperature. This symbol does
8
not appear in MANUAL mode.
Clock. The clock functions as a countdown when the
9
SLEEP function is in use.
10 Symbols indicating the current day.
TIMER symbol. If this symbol does not appear, the TIMER
is not active. If only the outline of the symbol appears, the
11
TIMER is active. A solid black symbol indicates that you are
in the TIMER setting menu.
SLEEP function symbol. If this symbol does not appear, the
SLEEP function is not active. If only the outline of the
symbol appears, the SLEEP function is active, meaning
12
that the unit will switch off at the end of the countdown
period set by the user and shown by symbol 9. A solid black
symbol indicates that you are in the SLEEP setting menu.
Flame symbol, indicating the current flame power. If flame
13
power is at level 5, the MAX message also appears.
Clock setting symbol. When this symbol appears, you can
14
adjust the clock setting displayed by the digits 9.
Flame power bars: one bar = low, five bars = high. These
15
bars only appear when the remote is in MANUAL mode.
Digits identifying the weekly TIMER program currently
16
selected.
Figure 2 - The Remote Control Display
Page 2
12
11
6
6
7
DESCRIPTION
Install the Remote Receiver
1. Remove the front panel from the unit by carefully lifting and
pulling forward. Verify the main power switch is off.
2. Attach the remote receiver to the connector labeled "SIT
WiFi Receiver" from the control panel inside the unit.
YELLOW WIRE
10
WHITE WIRE
9
8
VIOLET WIRE
3. Remove the adhesive backing from one side of the hook and
loop tape and attach it to the receiver. Remove the other side
backing and secure the receiver to the control board cover.
Setting Up the Remote Transmitter
5
Install/Replace Batteries
The remote control receiver located in the unit does not use batter-
ies. It is powered by the control board.
The handheld remote control transmitter is battery operated.
These batteries will need to be replaced periodically as part of the
normal maintenance of the unit. Replace the batteries with three
AAA sized 1.5V batteries.
The battery compartment panel is located on the back of the trans-
mitter. See Figure 4.
Figure 3
Figure 4
37855-0-0117