Empire Comfort Systems FRBTPL-1 Instructions D'installation page 3

Set the Clock
When the batteries are inserted into the remote, the time and day
must be set.
NOTE: This control uses a 24-hour clock.
1. Press the transmitter's adjustment button to adjust the hour.
See Figure 5.
2. Press the menu button to save the value. See Figure 5.
3. Repeat the process for the minutes and the day.
NOTE: The days of the week are indicated by the following two-
letter codes:
MO = Monday
TU = Tuesday
WE = Wednesday
TH = Thursday
FR = Friday
SA = Saturday
SU = Sunday
4. If the batteries are installed but the time and date need to be
adjusted, turn off the transmitter by holding down the power
button until the display back light turns off.
5. Simultaneously press the mode and menu buttons to enter
the Clock Setting Mode. See Figure 6.
6. Repeat steps 1 through 3 to adjust the settings.
NOTE: If the transmitter buttons are not used for seven seconds
while in the Clock Setting Mode, the transmitter will automati-
cally exit the Clock Setting Mode and assume the last settings
entered in the menu.
37855-0-0117
Figure 5
Figure 6
Linking the Remote Transmitter to the Remote Receiver
1. After the remote's clock is set, verify the unit's main electri-
cal power switch is off. Turn on the remote by holding the
"Power" button on the remote until the remote display panel
illuminates. See Figure 7.
2. Turn on the unit's main power switch. If electrical power is
present, the red and green LED's on the control board will
begin to flash alternately. See Figure 8.
Figure 7
Figure 8
Page 3