Cleaning And Storage - DS Produkte YF-418-12 Mode D'emploi

EN
If the control lamp lights up during use, the device is reheating. Do not press the
steam release button during the heating process in order not to slow this down
and to prevent a danger of scalding from hot water which may escape. Wait until
the control lamp goes out again.
7. If steam stops being produced, the water reservoir is empty. Allow the device to cool
down for a few minutes and then top up the water reservoir again (see the "Filling the
Water Reservoir" chapter). Never use the device without water to prevent damage
to the device!
Tips on Use
• Delicate items of clothing should be steamed inside out.
• Trousers are easier to smooth if they are hung up by the trouser legs.
• Do not hold down the steam release button (2) continuously during use. This reduc-
es the steam pressure.

Cleaning and Storage

NOTE!
■ Do not use any corrosive or abrasive cleaning agents or any metal objects to clean
the device. These can damage the surface.
1. Make sure that the device is switched off and the mains plug has been removed from
the plug socket.
2. Place the device on a water-resistant and heat-resistant surface.
3. Allow the device to cool down completely.
4. Empty the water reservoir (5): To do this, pull the water reservoir cap (4) out of the
water reservoir, hold the device over a sink or similar outlet and turn it upside down.
Allow all of the water to run out of the water reservoir.
5. Operate the device again for a short time and press the steam release button (2) in
order to allow any remaining amounts of water to evaporate.
18
5. Move the brush attachment (6) in strokes over the fabric
and press the steam release button at regular intervals as
you do so. However, do not keep the steam release button
held down constantly! It is important for the brush attach-
ment to touch the fabric so that it is freshened up.
6. Open the clip of the crease attachment (7) by pressing the
lever slightly towards the device. Clamp the fabric of the item
of clothing to be smoothed in the crease attachment and let
go of the lever again. Slowly pull down the item of clothing
and press the steam release button at regular intervals as
you do so. However, do not keep the steam release button
held down constantly!