Filling The Water Reservoir; Use - DS Produkte YF-418-12 Mode D'emploi

Filling the Water Reservoir

NOTE!
■ After use, the device may still be hot. Wait until the water reservoir has cooled com-
pletely before fi lling / emptying it.
■ Pour no more than 250 ml (note the max marking) of water into the water reservoir.
The device can be operated with both tap water and distilled water. However, if
you use tap water, the device will need to be regularly descaled (see the "Clean-
ing and Storage" chapter, "Descaling" section). If you use distilled water, there is
no need to descale the device.
1. Fill the measuring cup up to the MAX marking with water.
2. Pull the water reservoir cap (4) out of the water reservoir (5) Please note that it can-
not be completely detached from the device.
3. Pour the water from the measuring cup into the water reservoir. Here too you should
only pour up to the max marking.
4. Close the water reservoir cap again. Make sure that the water reservoir is properly
closed.

Use

NOTE!
■ Never use the device without water to prevent damage to the device!
■ There must be plenty of space around the item of clothing which is to be smoothed.
You may only perform vertical smoothing if the item of clothing is hanging on a hang-
er and cannot come into contact with other garments, objects, people or animals.
■ CAUTION – Danger of scalding! Only use the device once the control lamp has
gone out. Operating temperature has then been reached. If the device is used be-
fore the control lamp has gone out, hot water may escape.
■ Before using the device, read the care instructions for the fabric which is to be
smoothed. Some fabrics, leather and suede as well as fabrics with fl ounces,
sequins and appliqués must not be steamed!
1. Mount the attachment you want (see the "Mounting / Removing Attachments" chapter).
2. Pour water into the water reservoir (5) (see the "Filling the Water Reservoir" chapter).
3. Insert the mains plug into a properly installed plug socket that is easily accessible.
The control lamp (1) lights up and the device starts to heat up. When the control lamp
goes out, the device is ready for use.
17
4. Move the device without attachment in strokes over the fab-
ric and press the steam release button (2) at regular intervals
as you do so. However, do not keep the steam release
button held down constantly! It is important for the steam
bottom (8) to touch the fabric so that it is freshened up.
EN