Use; Cleaning And Storage; Emptying The Dust Container - DS Produkte SC04 Mode D'emploi

Use

PLEASE NOTE!
■ The device should only be used if it has been completely and correctly assembled!
The dust container and the fi lters must be inserted and must not be damaged.
If the dirt were to get inside the motor unit, this could damage the motor.
■ Make sure that the safety switches of the UV-C lamp are not blocked!
■ Always test the device fi rst on a small, inconspicuous spot.
1. Insert the mains plug into a properly installed plug socket that is easily accessible.
2. Place the device down fl at on the surface which is to be cleaned.
3. Press the On / Off switch (1) to switch on the device. The device starts to vacuum and
the UV-C lamp (10) switches on.
You can look through the viewing window (4) to check whether the UV-C lamp
is switched on.
4. Press the vibration button (14) to activate the vibration head (9).
The vibration shakes up the surface which is to be cleaned and the dust which
is agitated is sucked in through the suction opening (13).
5. Guide the device over the surface to be cleaned.
6. After vacuuming, press the On / Off switch to switch off the device.
7. Remove the mains plug from the plug socket.

Cleaning and Storage

PLEASE NOTE!
■ Before commencing the cleaning, note the safety instructions in the "Safety
Instructions" chapter!
■ Empty the dust container each time after you use the device. The fi lters must also be
regularly cleaned in order to prevent overloading of the motor.
■ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the de-
vice. These can damage the surface.
• Make sure that the mains plug has been pulled out and the device is disconnected
from the power.
• As required, wipe down the motor unit with a damp soft cloth. Then dry it with a soft
cloth.
• Wipe out the recess for the dust container (5) with a duster.
• Store the device in a dry, cool place that is not accessible to children and animals.

Emptying the Dust Container

1. Reach into the recess in the dust container (5) and pull it up and out of the motor
unit (3).
2. Reach into the opening and pull the fi lters out of the dust container.
17 EN