Troubleshooting - DS Produkte SC04 Mode D'emploi

EN
3. Empty the dust container.
4. Wipe out the dust container with a dry duster if necessary.
Cleaning the Dust and HEPA Filters
10. Insert the fi lters into the dust container (5).
11. Insert the dust container with the fi lters into the motor unit (3).
Cleaning the UV-C Lamp
PLEASE NOTE!
■ CAUTION – Danger of Burns! The UV-C lamp will become hot during use. Allow the
UV-C lamp to cool suffi ciently after using the device.
1. Undo the two screws on the cover (11) of the UV-C lamp (10) and take off the cover.
2. Wipe down the UV-C lamp with a dry duster. Notice: Make sure that you do not touch
the UV-C lamp with your fi ngers!
3. Place the cover back on and fi x it in place with the two screws.

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the prob-
lem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device
generates no
suction.
Low suction
force.
5. Unscrew the dust fi lter (15) anticlockwise until the arrow
on the dust fi lter points to the open padlock symbol (see
picture).
6. Detach the dust fi lter from the HEPA fi lter (16).
7. Tap out both fi lters and clean them with a soft brush if
necessary.
Notice: Do not clean the fi lters with water!
8. Place the dust fi lter on the HEPA fi lter.
9. Screw on the dust fi lter clockwise until the arrow on the
dust fi lter points to the closed padlock symbol.
Possible cause / solution / tips
• Is the mains plug inserted in the socket correctly? Correct the
fi t of the mains plug.
• Is the plug socket defective? Try another socket.
• Check the fuse of the mains connection.
• Is the device switched on? Press the On / Off switch (1).
• Is the dust container (5) too full? Empty the dust container.
• Are one or both fi lters heavily clogged up? Clean the fi lter(s).
• Is the suction opening (13) blocked? Switch off the device, pull
the mains plug out of the plug socket and remove the blockage.
18