Gaskets - England's Stove Works 25-CB120 Manuel D'installation

IMPROPER GASKET MAINTENANCE, INCLUDING FAILURE TO REPLACE GASKETS,
Gaskets
1. Door
 This unit comes with a ¾" rope gasket in the channel around the door opening that
should be replaced at least once every year. To replace the door gasket (Part # AC‐
DGKHD), the old gasket must first be removed entirely — prior to adding the new
adhesive, you may have to scrape the old cement from the channel. Once the
cement and gasket have been added, the door should be closed and latched for
twenty‐four hours to allow the cement to harden. See next page for more info.
2. Window
 If you are replacing the window gasket (Part # AC‐GGK), the new gasket will already
have adhesive on one side. Remove the paper on the adhesive side and place the
gasket around the outside edge of the glass, centered over the edge. Fold the gasket
edges over on the glass, forming a "U" shape.
Combustion
3.
 The Combustion Blower Gasket (Part # PU‐CBMG) should be inspected whenever you
remove or clean the Combustion Blower, and replaced if necessary.
4. Combustion Blower Motor
 The combustion blower motor gasket (Part # PU‐CBMG) generally does not need
replacement, as it is not normally removed from the unit. However, if the exhaust
blower is cleaned by removing the motor, rather than the entire blower assembly,
this gasket must be inspected and replaced as necessary.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
REPLACING COMPONENTS
CAN CAUSE AIR LEAKS RESULTING IN SMOKE‐BACKS.
Blower
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
44