Floor Protection - England's Stove Works 25-CB120 Manuel D'installation

 This pellet stove requires a non‐combustible floor protector if the stove is to be installed on a combustible
floor. If the floor the stove is to be installed on is already non‐combustible (i.e. a concrete floor in a
basement) and has an R value equal to or higher than .2, no floor protection is needed (although a
decorative floor protector can still be used for aesthetic reasons).
 Prefabricated floor protectors which are UL listed (ULC if Canada) or equivalent can be purchased or a floor
protector can be built from standard materials: two sheets of .5" thick cement board covered with ceramic
tile would be a suitable floor protector which meets the .2 R‐value requirement.
 When using any floor protector, consider that this stove is not only heavy but will induce heating and
cooling cycles on the floor protector which can damage tile and loosen mortar and grout joints. A hearth
rug is NOT an approved substitute for a proper hearth pad.
 For the US: The floor protector must extend at least 6 in. (152.4 mm) from the front & sides and 4 in.
(101.6 mm) from the rear.
 For Canada: The floor protector must extend at least 18.0 in. (457.2 mm) from the front of the unit, 8.0 in.
(203.2 mm) from the sides of the unit and 4.0 in. (101.6 mm) from the rear.
 In Canada, it is required that the non‐combustible floor protector is underneath and extends 2 in. (50.8
mm.) on either side of any horizontal venting runs AND/OR is directly underneath any vertical venting
pipe.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
FLOOR PROTECTION
(U.S.A.)
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
16