Care And Cleaning; Metal Rack; Cleaning The Grease Filter; Charcoal Filter Replacement - Bosch HMV9302 Mode D'emploi

USING YOUR MICROWAVE OVEN

CARE AND CLEANING

For best performance and safety, keep the oven clean
inside and outside. Take special care to keep the inner
door panel and the oven front frame free of food or
grease build-up. Never use rough powder or pads.
Wipe the microwave oven inside and out, including the
hood bottom cover, with a soft cloth and a warm (not hot)
mild detergent solution. Then rinse and wipe dry. Use a
chrome cleaner and polish on chrome, metal and alu-
minum surfaces. Wipe spatters immediately with a wet
paper towel, especially after cooking chicken or bacon.
Clean your oven weekly or more often, if needed.

METAL RACK

Wash the metal rack with a mild soap and a soft or nylon
scrub brush. Dry completely. Do not use abrasive
scrubbers or cleaners to clean rack.

CLEANING THE GREASE FILTER

The grease filter should be removed and cleaned often, at
least once a month.
1. To remove grease filter, slide filter to the side. Pull
filter downward and push to the other side. The filter
will drop out.
2. Wash in dishwasher or soak grease filter in hot water
and a mild detergent. Rinse well and shake to dry. Do
not use ammonia or place in a dishwasher. The
aluminum filter will darken.
3. To reinstall the filter, slide it into the side slot, then push
up and toward oven center to lock.
CAUTION
To avoid risk of personal injury or property
damage, do not operate oven hood without filter
in place.
CHARCOAL FILTER
REPLACEMENT
If your oven is vented inside, the charcoal filter should be
replaced every 6 to 12 months, and more often if neces-
sary. The charcoal filter cannot be cleaned.
1. Unplug the oven or turn off power at the main power
supply.
2. Remove the two vent grill mounting screws.
(2 middle screws)
3. Tip the grill forward, then lift itout.
4. Remove old filter.
5. Slide a new charcoal filter into place. The filter should
rest at the angle shown.
6. Slide the bottom of the grill into place. Push the top
until it snaps into place. Replace the mounting screws.
Turn the power back on at the main power supply and
set the clock.
28