Safety Notes - Chauvet Professional NET-X Manuel D'utilisation

Safety Notes

Please read the following Safety Notes carefully before starting to work with the product.
These notes provide important safety information about the installation, usage, and
maintenance.
·
Always connect this product to a grounded circuit.
·
Make sure the power cord is not crimped or damaged.
·
Always connect this product to a power source with the proper voltage as
listed on the product sticker.
·
Do not operate the product if there is damage to the housing.
·
This product is for indoor use only! It is rated IP20. Do not expose the
product to rain or moisture.
·
Always disconnect this product from power before cleaning it or changing the
fuse.
·
Never disconnect the product from the power source by pulling or tugging on
the cord.
·
If mounting the product overhead, always secure it using a safety cable.
·
Make sure there are no flammable materials close to the product when it is
operating.
·
This product is not intended for permanent installation.
·
Never connect the product to a dimmer or a rheostat.
·
Always install the product in a location with adequate ventilation.
·
Do not operate the product in an ambient temperature higher than
104 °F (40 °C).
·
This product contains no user-serviceable parts. Any reference to servicing in
this User Manual will only apply to properly trained Chauvet certified
technicians. Do not open the housing or attempt any repairs.
·
Any damages caused by manual modifications are not subject to warranty.
Chauvet will not accept liability for damage caused by unauthorized
modifications or not observing the safety warnings and instructions in the
manual.
·
All applicable local codes and regulations apply for proper installation of this
product.
·
In the event of a serious operating problem, stop using the product
immediately.
·
If the product requires repair contact Chauvet. For more information see
Returns and Contact Us.
·
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
Keep this User Manual for future reference.
Net-X™ User Manual Rev. 2
Before You Begin
Page 7 of 62