KERN VHB Mode D'emploi page 30

PRE-
Press TARE button

Press the numeric

the desired value.
To move to the next segment, press the key

Repeat this action until the display shows the desired tare value.

To activate the tare weight (but not for storing): Press the

seconds, to confirm the value.
The tare weight is now activated.

"NET" appears.

If the system is loaded at this moment, the net value of the weighed weight

appears on the display.
If the system is unloaded, the system indicates the entered tare value negative.

The entered value remains active until the weighing system is turned off, a new

tare weight entered, a new load tared (See 7.3.) or if a reset to zero is carried
out:
The weighing system is loaded: Press the

value will be reset to zero and the system reverts to standard weighing
mode.
or
The weighing system is unloaded: Press

carried out and the system reverts to standard weighing mode.
To activate and store the tare weight: Confirm all segments by pressing the

key.
The tare weight is now activated and stored.

"NET" appears.

If the system is loaded at this moment, the net value of the weighed weight

appears on the display.
If the system is unloaded, the entered tare value is shown negative.

The entered value remains active even after the system was turned off, until a

new tare weight is entered, a new load tared (See 7.3.) or a reset to zero is
carried out.
The weighing system is loaded: Press the

value will be reset to zero and the system reverts to standard weighing
mode.
or
The weighing system is unloaded: Press button. A reset to zero is carried

out and the system reverts to standard weighing mode.
12
PRE-
TOTAL
TARE
up or down key until the flashing number has reached
TARE
TARE
key for three
PRE-
TARE
key for two seconds. The tare
TARE
button A reset to zero is
PRE-
TARE key for two seconds. The tare
VHB/VHS-BA-e-1613
TARE