Installation Of Wall Anchors - Aerus Laundry PRO Manuel De L'utilisateur

INSTALLATION OF WALL ANCHORS OR SCREWS
Level and place the Laundry Pro to the wall
1
and mark where the two (2) keyholes are on
each side with a pencil.
NOTE:
Washing machine and cold water faucet must
be within 4 feet (1.21 m) of the right side of unit.
A. If using supplied wall anchors, drill two 3/16" (4.76 mm)
diameter holes. Place two wall anchors into the wall. Install
two supplied screws and tighten until almost all the way in.
B. If mounting to wall studs, drill two 3/32" (2.381 mm) diameter
holes approximately 1" (25.4 mm) deep. Install two supplied
screws and tighten until almost all the way in.
Position the keyholes of the Laundry Pro onto the screws
2
(not shown). Finish tightening screws enough to securely
mount unit, but still allowing it to be removed from wall.
Remove unit from wall.
6
CAUTION:
This appliance must be installed in a level,
horizontal configuration as shown. Do not
install the unit vertically, at an angle, or on its
back Failure to follow these instructions may
prevent the internal moisture sensor
from operating properly.
Screws (not shown)
16" (40.64 cm) OC
Keyholes