Aerus Laundry PRO Manuel De L'utilisateur page 11

FOR WASHERS THAT REQUIRE HOT & COLD WATER INPUT
Some washing machine models require water pressure to both the Hot and
Cold valves for proper operation. In some cases, if only the COLD water side
is connected, the water valve will not operate or the washing machine will not
fill to the proper level. To solve this problem, the installation of a "Y" adapter
(available at most hardware stores) may be used. The use of the "Y" adapter
allows water to flow equally through both the HOT and COLD water valves.
Optional stainless steel hose (49738-EURO, 49701-US) must be installed
on the hot water connection. To Install, turn water off at the valves and
disconnect the existing HOT water hose (at the valve and washing machine)
Connect the "Y" adapter to the Outlet on your Laundry Pro, then connect
both the optional stainless steel hose (49738-EURO, 49701-US) and Cold
hose from your washer to the "Y" adapter (see diagram below). Operate your
washer on the WARM/WARM setting (your Laundry Pro will still be
using just cold water).
CAUTION:
When connecting hoses to your
Laundry Pro hand start the hose
connector(s) Using adjustable pliers
finish tightening hose connector(s).
NOTE:
Your hot source water valve
will not have a hose connected to it.
Make sure it is fully turned off. It is
recommended you secure a cap
(available at most home improvement
stores) to prevent leakage.
Connect the "Y" adapter to the
OUTLET on your Laundry Pro. Be
sure to hold the fitting with pliers
while tightening the adapter.
Disconnect this stainless
steel hose from the
OUTLET on your
Laundry Pro,
then connect
it to the "Y"
adapter.
Stainless steel hose supplied
Connect to COLD water inlet
on washing machine
CAUTION:
Turn off both water valves (hot and cold)
before disconnecting hoses. Failure to
follow these instructions may result in
water leakage and/or possible injury
from hot water.
Connect to household plumbing
COLD water valve
"Y" adapter
Make sure the "Y" adapter
valve is in the on position.
Disconnect the existing hose
from the HOT valve and washing
machine and remove. Replace
with Laundry Pro.
Connect to HOT water inlet
on washing machine
with optional stainless
steel hose. Part No.
49738-EURO, 49701-US
(not included).
11