Preparing For Use - Philips Slim Powerstylist HP4693 Mode D'emploi

Masquer les pouces Voir aussi pour Slim Powerstylist HP4693:
Table des Matières

Publicité

When used in a bathroom, unplug the appliance after use since
the proximity of water presents a risk, even when the appliance is
switched off.
For additional protection, we advise you to install a residual
current device (RCD) with a rated residual operating current not
exceeding 30mA in the electrical circuit supplying the bathroom.
Ask your installer for advice.
Always make sure that the attachments are completely dry - on
the inside as well as on the outside - before you fit them onto the
styler.
The attachments will become hot during use. Prevent contact
with the skin.
Never block the air inlet grille.
Regularly detach the air inlet grille and clean it with a moist cloth.
If the air inlet grille is not cleaned regularly, it may get blocked
and the appliance may overheat. (fig. 2)
If the appliance overheats, it will switch off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
put the plug back into the socket again, check the grille to make
sure it is not blocked by fluff, hair, etc.
Always unplug the appliance after use.
Keep the appliance away from children.
Wait until the appliance is cool before storing it.
Always switch the appliance off before putting it down, even for a
moment.

Preparing for use

Hair
1
The Slim Powerstylist is most effective when the hair is slightly
damp. Slightly dampen your hair when it is dry. Never use the
appliance on wet hair!
2
Comb or brush the hair so that it is untangled and smooth.
3
Use a comb to divide the hair into locks.
Do not put too much hair in one lock.
ENGLISH
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Slim powerstylist hp4692Slim powerstylist hp4691

Table des Matières