Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.12 Drilling
1. Set the function selector ring to the "drilling" position
2. Set the forward/reverse switch to the "forward" position.
5.13 Hammer drilling
1. Set the function selector ring to the "hammer drilling" position
2. Set the forward/reverse switch to the "forward" position.
6
Care and maintenance of cordless tools
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance
tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning
agents containing silicone as these may attack the plastic parts.
Care of the Liion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning
agents containing silicone as these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals
and make sure that they all function correctly.
• Do not operate the cordless tool if signs of damage are found or if parts
malfunction. Have the tool repaired by Hilti Service immediately.
• After cleaning and maintenance, fit all guards or protective devices and
check that they function correctly.
7
Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
12
English
Printed: 19.06.2019 | Doc-Nr: PUB / 5245424 / 000 / 04
.
2125997
*2125997*
.
Publicité
Table des Matières
