NOMA 052-4345-2 Guide D'utilisation page 16

Toll-free: 1-866-827-4985 · model nos. 052-4345-2/052-6934-8
Warning!
or circuit breaker box before installing, servicing or cleaning.
Never clean the fan while in use!
Because of the fan's natural movement, some connections may become loose. Check the
support connections, brackets and blade attachments regularly. Make sure they are secure.
There is no need to oil your fan. The motor has permanently-lubricated bearings.
Cleaning
When cleaning the fan, use a soft brush or lint-free cloth to prevent scratching. A vacuum
cleaner brush nozzle can remove heavier dust.
Remove surface smudges or accumulated dirt and dust using a mild detergent and a slightly
dampened cloth. Never use abrasive cleaning agents, as they will damage the finish.
Clean wood finish blades with a furniture polishing cloth. Occasionally apply a light coat of
furniture polish for added protection and beauty.
To prevent bending the blades during cleaning, support the blades so that no pressure is
applied to them.
If the ceiling fan works abnormally, follow the instructions below or consult a qualified
electrician.
WARNING!
main fuse or circuit breaker box before servicing.
Problem
Possible reason
Blade screws are loose.
The mounting bracket or canopy is
loose.
Screws securing decorative housing
to mounting bracket are loose.
Glass shade is loose.
Fan is noisy
Screws securing downrod to
during
mounting bracket are loose.
operation
Wire connectors are vibrating
against the inside of the canopy.
Light kit or light bulb is not firmly
attached.
Canopy is rattling against ceiling.
Motor housing screws are loose.
Fuse or circuit breaker is blown.
Loose or incorrect power line,
connections to the fan or switch
Fan does
not start wires.
Reverse switch is stuck in the middle.
Remote is not working.
Solution
Tighten the blade screws.
Check and fasten the screws.
Check and fasten the screws.
Tighten by hand, as necessary.
Check and fasten the screws.
Disconnect power at fuse box, loosen
canopy and reposition connectors.
Remove and reattach.
Be sure canopy is not touching ceiling.
Check and fasten the screws.
Check main fuse and branch circuit fuses
or circuit breaker. Repair as necessary.
Check all the wire connections to fan and
housing wiring. Repair as necessary.
Make sure the reverse swith is set to one
side only.
Check and ensure the remote works.