NOMA 052-4345-2 Guide D'utilisation page 10

Toll-free: 1-866-827-4985 · model nos. 052-4345-2/052-6934-8
3.3 Securing Downrod Assembly
Raise the canopy.
Loosen the two downrod set screws on the
coupling (fig. 14).
Insert the downrod into the coupling. Make sure to
align the holes of these two parts.
Install the peaked pin through the aligned holes and
secure it with the clip.
Tighten the two downrod set screws on the coupling
(fig. 14).
3.4 Hanging Fan Assembly to Mounting Bracket
Carefully lift the fan assembly and place it on the
mounting bracket.
Rotate the fan assembly until the notch on the nylon
ball fits against the ridge on the mounting bracket
(fig. 15).
With the mounting bracket holding the fan assembly,
follow the wiring instructions (step 4).
4. Wiring Instructions
WARNING!
All wiring must be in accordance with national and local electrical codes,
including fire-rated construction. If you are unfamiliar with wiring, consult
a qualified electrician.
If you are not sure whether the electrical outlet box and fan are grounded,
contact a licensed electrician for advice. These parts must be grounded!
or circuit breaker box before installing, servicing or cleaning.
4.1 Installing Receiver Assembly
CODE SWITCH
· CODE SWITCH: Codes are set by pushing dip switches up or down. It is imperative that
the code used for both transmitter and receiver is exactly the same; otherwise remote
controller will not work. Please note the code switch will enable you to operate a second
remote controller independently. For example, if you have two ceiling fans with 2 remote
can operate each ceiling fan independently.
· Your remote control is ready for use after battery installation.
Clip
Peaked
pin
15
Mounting
bracket
Nylon ball
Screw