Hama 00012083 Mode D'emploi page 5

When the remote control instead of 1 only
every 3 seconds a new code is supposed to
send, you go on as follows.
You press within 6 seconds according
to pressures of the key P+ (14) (and/or
POWER (2)) how in before described, the
key P+ (14) or P- (14) still once. The remote
control sends now a new code only every
3 seconds. Through that you win more time
in order to abort the process, however, the
code search through that lasts also longer.
Code-identification
The code identification offers you the
possibility, already to determine entered
codes that are stored in the remote control.
So go ahead.
• Hold the key setup (4) pressed for approx.
3 seconds until the red LED (1) lights up
permanently.
• Press the source key (3) (TV, DVD, STB)
shortly.
• You press the key setup (4) shortly, the
red LED (1) goes out shortly during the
keystroke.
• In order to find the first number, you press
the numeric keys (8) from 0 to 9.
• If the red LED (1) goes out shortly, it is the
first
stored number.
• In order to find the second number, you
press in turn the numeric keys (8) from 0
to 9 until the red LED (1) goes out.
• Repeat the process for the third and the
fourth number.
• The red LED (1) goes out as soon as the
key was pressed for the fourth number.
• The code-identification is now finished.
8
Normal use
After you have carried out the programming
of your remote control for yours audio/video
device, the remote control works in the most
common primary functions as the original
remote control of the respective device.
Focus your remote control on the wanted
device and press the corresponding source
key. The red LED will light up shortly.
They activate the functions now through
pressing of the corresponding function key of
your universal remote control.
At every keystroke the red LED lights up
shortly.
Possibly every function of your original
remote control is not directly available on the
universal remote control.
In particular near newer devices it is possible
that the functions are first of all put aside or
not at all available among other keys than
expected.
With the AV Taste you choose usually the
AV input of the TV set for e.g. the STB
receiver or the video recorder.
Special functions
„electronic program"
The key EPG (12) corresponds to the function
„Electronic Program Guide" and has different
functions, depending on which device this
is used.
At STB - or VCR - codes keep you up the key
a programming carry out, provided that
your video recorder about a SHOWVIEW
- function.
Debugging
The remote control does not function:
• Check the batteries of the remote control
are correctly inserted and the polarity
+/- is right
• Check your devices are correctly
connected and turned on.
• If the batteries are too weak, you
exchange these through new.
• Several device codes are performed
under the brand name of my device. How
do I determine the correct device code?
• In order to determine the correct
device code for your device, you try out
the codes after each other until most
functions of the device function properly.
The devices react only to some commands of
the remote control:
• You test further codes, to which according
to devices by the commands react.
• If the manual code input and the
automatic code search do not lead to
the success, it can happen in special
individual cases that the device is not
compatible to your universal remote
control.
9