Surface Burners; Cooktop Surface - Samsung NX58H9500WS Manuel D'utilisation

Surface burners

Burner controls
Make sure all surface burner knobs are in the OFF position.
CAUTION
• Do not clean the control knobs in a dish washer.
• Do not spray cleansers directly onto the control panel. Moisture entering the electric
circuits may cause electric shock or product damage.

Cooktop surface

The porcelain-enameled cooktop surface needs to be kept clean. It is advisable to remove food spills
immediately after they took place.
CAUTION
• Do not use a steel-wool pad or abrasive cleaner, which can scratch or damage the enamel
surface.
• Do not remove the cooktop surface for cleaning purposes. The gas lines leading to the
burner manifolds can be damaged, resulting in a fire or system failure.
Manual User_NX58H9500WS_DG68-00566A-01_EN_NonPF.indd 54
1. Pull out the knobs from the control valve
stems as shown.
2. Clean the knobs in warm, soapy water. Then,
rinse and dry them thoroughly.
3. Clean the stainless steel surfaces using
stainless steel cleaner.
4. Reinsert the knobs into the control valve
stems.
1. Turn off all surface burners.
2. Wait until all burner grates cool down, and
then remove them.
3. Clean the cooktop surface using a soft cloth.
If food spills run into gaps of the burner
components, remove the burner cap and the
head, and wipe out the spills.
4. When cleaning is finished, reinsert the burner
components, and put the burner grates into
position.
English - 54
2014-07-30 1:02:05