Step 6. Level The Range; Step 7. Assemble The Surface Burners - Samsung NX58 9420S Manuel D'installation

Step 6. Level the range

Leveling leg
Install_NX58M9420SS_DG68-00906A-03_EN+MES+CFR.indb 23
1. Make sure the range is positioned where
you want it.
2. Using a wrench, level the range by
turning the front leveling legs in or out
as necessary. Counterclockwise shortens
the leg and lowers the range. Clockwise
lengthens the leg and raises the range.
NOTES
• Adjusting the two front legs is usually
sufficient, but adjust all four legs if
necessary.
• Adjust the leveling legs only as far as
necessary to level the range. Extending
the leveling legs more than necessary or
removing legs can cause the range to be
unstable.
3. If range is next to or between cabinets,
make sure the cooktop (without the
surface burner grates) is level with the
countertops.
4. Position an oven rack in the center rack
position.
5. Check the level of the range with a
carpenter level using the two positions
shown at left.
6. After the range becomes level, slide the
range away from the wall so that the
anti-tip bracket can be installed.

Step 7. Assemble the surface burners

Do not operate the surface burners without
all burner parts in place.
1. Position surface burner heads on top of
2. Place the matching size caps on top of
Precise Simmer Burner (RR)
The caps on Precise simmer burner
Flat surface Concave line
(RR) and inside Dual Burner (RF) can be
interchangeably used.
3. Place the left, center, and right surface
CAUTION
the surface burner manifolds as shown at
right. The electrodes will fit into the slot
in the bottom of the heads. Make sure the
surface burner heads are flat and parallel
with the cooktop.
each surface burner head.
NOTE
burner grates on the cooktop. The edges
of the grates should match up with the
edges of the cooktop.
English 23
10/24/2018 12:51:43 PM